Data from Baldwin Locomotive Works Specification for Engines, 1888, as digitized by the DeGolyer Library of Southern Methodist University Vol 15, p. 40. Works numbers were 9899 in March 1889 and 11707 in March 1891.
These Moguls started out on FC Agricola (de (Cordoba a Motzorongo y Rio Tinto, to give it its full geographical due). Passenger trains on the main line covered 42 km at the rate of 24 km/h. The FA would later extend its line to Tuxtepec and to Santa Lucrecia on the Tehuantepec line.
Later the Vera Cruz & Pacific would buy up the lines and the locomotives; see Locobase 11922.
Principal Dimensions by Steve Llanso of Middle Run Media | |
---|---|
Class | Cordoba |
Locobase ID | 11596 |
Railroad | Ferrocarril Agricola |
Country | Mexico |
Whyte | 2-6-0 |
Number in Class | 2 |
Road Numbers | 1, 4 |
Gauge | Std |
Number Built | 2 |
Builder | Burnham, Parry, Williams & Co |
Year | 1889 |
Valve Gear | Stephenson |
Locomotive Length and Weight | |
Driver Wheelbase (ft / m) | 11 / 3.35 |
Engine Wheelbase (ft / m) | 17 / 5.18 |
Ratio of driving wheelbase to overall engine wheelbase | 0.65 |
Overall Wheelbase (engine & tender) (ft / m) | |
Axle Loading (Maximum Weight per Axle) (lbs / kg) | 18,290 / 8296 |
Weight on Drivers (lbs / kg) | 41,920 / 19,015 |
Engine Weight (lbs / kg) | 51,920 / 23,551 |
Tender Loaded Weight (lbs / kg) | |
Total Engine and Tender Weight (lbs / kg) | |
Tender Water Capacity (gals / ML) | 1600 / 6.06 |
Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | |
Minimum weight of rail (calculated) (lb/yd / kg/m) | 23 / 11.50 |
Geometry Relating to Tractive Effort | |
Driver Diameter (in / mm) | 40 / 1016 |
Boiler Pressure (psi / kPa) | 130 / 900 |
High Pressure Cylinders (dia x stroke) (in / mm) | 14" x 18" / 356x457 |
Tractive Effort (lbs / kg) | 9746 / 4420.72 |
Factor of Adhesion (Weight on Drivers/Tractive Effort) | 4.30 |
Heating Ability | |
Tubes (number - dia) (in / mm) | 148 - 1.5" / 38 |
Flues (number - dia) (in / mm) | |
Flue/Tube length (ft / m) | 8 / 2.44 |
Firebox Area (sq ft / m2) | |
Grate Area (sq ft / m2) | 9.60 / 0.89 |
Evaporative Heating Surface (sq ft / m2) | |
Superheating Surface (sq ft / m2) | |
Combined Heating Surface (sq ft / m2) | |
Evaporative Heating Surface/Cylinder Volume | |
Computations Relating to Power Output (More Information) | |
Robert LeMassena's Power Computation | 1248 |
Same as above plus superheater percentage | 1248 |
Same as above but substitute firebox area for grate area | |
Power L1 | |
Power MT |