Data from Baldwin Locomotive Works Specification for Engines as digitized by the DeGolyer Library of Southern Methodist University Vol 19, p. 147. Works number was 14086-14087 in September 1894.
Gene Connelly lists the 5 as an 0-4-2T, but the Baldwin specifications show that both have the wheelbase shown above. This distance more likely reflects 3 axles than 2.
| Principal Dimensions by Steve Llanso of Middle Run Media | |
|---|---|
| Class | CHa1005 |
| Locobase ID | 12126 |
| Railroad | State TransCaucasus |
| Country | Russia |
| Whyte | 0-6-2T |
| Number in Class | 2 |
| Road Numbers | 5-6 |
| Gauge | 90 cm |
| Number Built | 2 |
| Builder | Burnham, Williams & Co |
| Year | 1894 |
| Valve Gear | Stephenson |
| Locomotive Length and Weight | |
| Driver Wheelbase (ft / m) | 7.75 / 2.36 |
| Engine Wheelbase (ft / m) | 16.25 / 4.95 |
| Ratio of driving wheelbase to overall engine wheelbase | 0.48 |
| Overall Wheelbase (engine & tender) (ft / m) | 16.25 / 4.95 |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | |
| Weight on Drivers (lbs / kg) | 47,000 / 21,319 |
| Engine Weight (lbs / kg) | 54,000 / 24,494 |
| Tender Loaded Weight (lbs / kg) | |
| Total Engine and Tender Weight (lbs / kg) | |
| Tender Water Capacity (gals / ML) | 800 / 3.03 |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 26 / 13 |
| Geometry Relating to Tractive Effort | |
| Driver Diameter (in / mm) | 36.50 / 927 |
| Boiler Pressure (psi / kPa) | 180 / 1240 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 8.5" x 18" / 216x457 |
| Low Pressure Cylinders (dia x stroke) (in / mm) | 14" x 18" / 356x457 |
| Tractive Effort (lbs / kg) | 7966 / 3613.32 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 5.90 |
| Heating Ability | |
| Tubes (number - dia) (in / mm) | 75 - 2" / 51 |
| Flues (number - dia) (in / mm) | |
| Flue/Tube length (ft / m) | 11.08 / 3.38 |
| Firebox Area (sq ft / m2) | 54 / 5.02 |
| Grate Area (sq ft / m2) | 8 / 0.74 |
| Evaporative Heating Surface (sq ft / m2) | 485 / 45.07 |
| Superheating Surface (sq ft / m2) | |
| Combined Heating Surface (sq ft / m2) | 485 / 45.07 |
| Evaporative Heating Surface/Cylinder Volume | 410.26 |
| Computations Relating to Power Output (More Information) | |
| Robert LeMassena's Power Computation | 1440 |
| Same as above plus superheater percentage | 1440 |
| Same as above but substitute firebox area for grate area | 9720 |
| Power L1 | 2578 |
| Power MT | 362.78 |