Data from Baldwin Locomotive Works Specification for Engines as digitized by the DeGolyer Library of Southern Methodist University, Vol 79, p. 182. Works number was 60566 in July 1928.
At least as far as Baldwin was concerned, this rear-bogie tank diverged from an earlier pattern by using a truck to support the rear tank. The oil tank rode over the boiler as did a 300 US gallon (1,136 litre) saddle tank for part of the water supply. The rear tank carried 400 gallons (1,514 litres) of water and had enough fuel space for 1/2 cord of wood.
| Principal Dimensions by Steve Llanso of Middle Run Media | |
|---|---|
| Class | Catatumbo |
| Locobase ID | 15385 |
| Railroad | Gran Ferrocarril del Tachira |
| Country | Venezuela |
| Whyte | 0-4-4ST |
| Number in Class | 1 |
| Road Numbers | 13 |
| Gauge | Metre |
| Number Built | 1 |
| Builder | Baldwin |
| Year | 1928 |
| Valve Gear | Stephenson |
| Locomotive Length and Weight | |
| Driver Wheelbase (ft / m) | 5 / 1.52 |
| Engine Wheelbase (ft / m) | 13.92 / 4.24 |
| Ratio of driving wheelbase to overall engine wheelbase | 0.36 |
| Overall Wheelbase (engine & tender) (ft / m) | 13.92 / 4.24 |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | |
| Weight on Drivers (lbs / kg) | 29,500 / 13,381 |
| Engine Weight (lbs / kg) | 39,000 / 17,690 |
| Tender Loaded Weight (lbs / kg) | |
| Total Engine and Tender Weight (lbs / kg) | 39,000 / 17,690 |
| Tender Water Capacity (gals / ML) | 700 / 2.65 |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | 300 / 1136 |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 25 / 12.50 |
| Geometry Relating to Tractive Effort | |
| Driver Diameter (in / mm) | 37 / 940 |
| Boiler Pressure (psi / kPa) | 160 / 1100 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 10" x 16" / 254x406 |
| Tractive Effort (lbs / kg) | 5881 / 2667.58 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 5.02 |
| Heating Ability | |
| Tubes (number - dia) (in / mm) | 82 - 1.5" / 38 |
| Flues (number - dia) (in / mm) | |
| Flue/Tube length (ft / m) | 7.98 / 2.43 |
| Firebox Area (sq ft / m2) | 32 / 2.97 |
| Grate Area (sq ft / m2) | 5.40 / 0.50 |
| Evaporative Heating Surface (sq ft / m2) | 286 / 26.58 |
| Superheating Surface (sq ft / m2) | |
| Combined Heating Surface (sq ft / m2) | 286 / 26.58 |
| Evaporative Heating Surface/Cylinder Volume | 196.64 |
| Computations Relating to Power Output (More Information) | |
| Robert LeMassena's Power Computation | 864 |
| Same as above plus superheater percentage | 864 |
| Same as above but substitute firebox area for grate area | 5120 |
| Power L1 | 3026 |
| Power MT | 452.28 |