Data from Roy V Wright (Ed.) 1912 Locomotive Cyclopedia of American Practice, Sixth Edition (New York: Simmons-Boardman Publishing Company, 1912), p. 154. Works number was 48349 in August 1910.
M A Hanna & Company were the buyers and they sent this saddle tank to Michigan. Locobase suspects that the count of 164 tubes given in the Locomotive Cyclopedia was a typographical error and that 154 tubes was a more likely figure given the stated tube heating surface area. Note the long wheelbase for an 0-4-0 saddle tank.
| Principal Dimensions by Steve Llanso of Middle Run Media | |
|---|---|
| Class | 3 |
| Locobase ID | 15029 |
| Railroad | Detroit Iron & Steel |
| Country | USA |
| Whyte | 0-4-0ST |
| Number in Class | 1 |
| Road Numbers | 3 |
| Gauge | Std |
| Number Built | 1 |
| Builder | Alco-Pittsburgh |
| Year | 1910 |
| Valve Gear | Stephenson |
| Locomotive Length and Weight | |
| Driver Wheelbase (ft / m) | 7 / 2.13 |
| Engine Wheelbase (ft / m) | 7 / 2.13 |
| Ratio of driving wheelbase to overall engine wheelbase | 1 |
| Overall Wheelbase (engine & tender) (ft / m) | 7 / 2.13 |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | |
| Weight on Drivers (lbs / kg) | 103,500 / 46,947 |
| Engine Weight (lbs / kg) | 103,500 / 46,947 |
| Tender Loaded Weight (lbs / kg) | |
| Total Engine and Tender Weight (lbs / kg) | |
| Tender Water Capacity (gals / ML) | 1500 / 5.68 |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | 1 / 1 |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 86 / 43 |
| Geometry Relating to Tractive Effort | |
| Driver Diameter (in / mm) | 46 / 1168 |
| Boiler Pressure (psi / kPa) | 170 / 1170 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 17" x 24" / 432x610 |
| Tractive Effort (lbs / kg) | 21,788 / 9882.88 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 4.75 |
| Heating Ability | |
| Tubes (number - dia) (in / mm) | 154 - 2" / 51 |
| Flues (number - dia) (in / mm) | |
| Flue/Tube length (ft / m) | 12.08 / 3.68 |
| Firebox Area (sq ft / m2) | 85 / 7.90 |
| Grate Area (sq ft / m2) | 12.90 / 1.20 |
| Evaporative Heating Surface (sq ft / m2) | 1050 / 97.55 |
| Superheating Surface (sq ft / m2) | |
| Combined Heating Surface (sq ft / m2) | 1050 / 97.55 |
| Evaporative Heating Surface/Cylinder Volume | 166.40 |
| Computations Relating to Power Output (More Information) | |
| Robert LeMassena's Power Computation | 2193 |
| Same as above plus superheater percentage | 2193 |
| Same as above but substitute firebox area for grate area | 14,450 |
| Power L1 | 3047 |
| Power MT | 129.81 |