Data provided by Carlos Alberto Fernandez Priotti in Bryan Attewell ([] Steam Locomotive simulator program (April 2000); and D Rock Carling, 4-8-0 Tender Locomotives (New York: Drake Publishers Inc, 1972), p. and serial #193 in table pp. 106-107.
Fernandez, writing in [] (visited August 2002), wrote these engines were ordered from the Nord to confront the problem of rapidly growing freight service on a relatively lightly built line.
Although limited to a 12 1/2-metric ton axle loading, these Twelve-wheelers proved to have considerable power as they worked the BA-Rosario line through Mercedes and Pergamino. The profile showed the steam and sand domes joined in a long casing over the middle driving axles and a noticeable gap between the third and fourth drivers.
Successful as these locomotives proved to be, the postwar era saw a relatively rapid introduction of diesel-electrics and the class was scrapped by the end of the 1950s.
| Principal Dimensions by Steve Llanso of Middle Run Media | |
|---|---|
| Class | Serie 600 |
| Locobase ID | 3661 |
| Railroad | Buenos Aires (CGBA) |
| Country | Argentina |
| Whyte | 4-8-0 |
| Number in Class | 8 |
| Road Numbers | 601-608 |
| Gauge | Metre |
| Number Built | 8 |
| Builder | Nord |
| Year | 1930 |
| Valve Gear | Walschaert |
| Locomotive Length and Weight | |
| Driver Wheelbase (ft / m) | |
| Engine Wheelbase (ft / m) | |
| Ratio of driving wheelbase to overall engine wheelbase | |
| Overall Wheelbase (engine & tender) (ft / m) | |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | 27,558 / 12,500 |
| Weight on Drivers (lbs / kg) | 109,984 / 49,888 |
| Engine Weight (lbs / kg) | |
| Tender Loaded Weight (lbs / kg) | |
| Total Engine and Tender Weight (lbs / kg) | |
| Tender Water Capacity (gals / ML) | 4400 / 16.67 |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | 6.60 / 6 |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 46 / 23 |
| Geometry Relating to Tractive Effort | |
| Driver Diameter (in / mm) | 47.20 / 1200 |
| Boiler Pressure (psi / kPa) | 197.30 / 1360 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 17.3" x 22.1" / 439x561 (3) |
| Tractive Effort (lbs / kg) | 35,252 / 15990.06 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 3.12 |
| Heating Ability | |
| Tubes (number - dia) (in / mm) | |
| Flues (number - dia) (in / mm) | |
| Flue/Tube length (ft / m) | 14.33 / 4.37 |
| Firebox Area (sq ft / m2) | |
| Grate Area (sq ft / m2) | 28.50 / 2.65 |
| Evaporative Heating Surface (sq ft / m2) | 1739 / 161.62 |
| Superheating Surface (sq ft / m2) | 578 / 53.72 |
| Combined Heating Surface (sq ft / m2) | 2317 / 215.34 |
| Evaporative Heating Surface/Cylinder Volume | 192.82 |
| Computations Relating to Power Output (More Information) | |
| Robert LeMassena's Power Computation | 5623 |
| Same as above plus superheater percentage | 7029 |
| Same as above but substitute firebox area for grate area | |
| Power L1 | |
| Power MT | |