Data from Edouard Sauvage, "Four-Cylinder Compound Locomotives in France", Railroad Gazette, Volume XXXII [32], No.39 (28 September 1900), pp.629-631 using information compiled through direct communications with the various designers; Henri De Parville (ed), La Nature (Vol 28, 1900), pp 281-282; "Recent French Locomotives," The Locomotive & Railway Carriage & Wagon Review, Vol IV (February 1899), p. 18; and Maurice Demoulin, Traite Pratique de la Machine Locomotive (Paris: Libraire Polytechnique, Baudry et Cie, 1898), pp. 94-95.
This was the American-type Eight-wheeler on which the 4-6-0 shown in Locobase 6807 was based. Like the 1301s, the design used du Bousquet's particular variant of the de Glehn system in which the LP cylinders drove the first coupled axle and the HP cylinders turned the second coupled axle. Large-diameter boiler tubes were of the Serve design with internal fins. The illustration shows the Belpaire firebox and dome over the leading driving axle.
According to the author of the Recent French Locomotives, these engines proved the superiority of the four-cylinder compound "clearly" when compared to the Est's own Flaman-designed 801 class (Locobase 3056). The comparison included not only fuel economy at equal power, but "...specifically with very heavy and fast express trains, which were hauled more easily and quickly than by the other locomotives."
When the 1760 was run the Schaerbeck-Ostend and Schaerbeck-Ans sections of the Belgian State Railways, it pulled 230 tons of trains over the 57.8 miles of the latter section in about 56 minutes. This was a performance that up to that time had not been "...approached by any engine of the Belgian State."
Data from "Locomotives for the Southern Railway of France", Engineering, Volume 68, (10 November 1899), pp. 592-594; "220 n° 1 751 à 1 774 puis 220-751 à 774 du Midi" on the WikiMidi website at [], last accessed 31 October 2026; and "The New Locomotive on the Southern Railroad of France", Railroad Gazette, Volume XXXII [32], No. 6 (23 February 1900), p. 115.as having recently gone into service. Works numbers were 2600-2611 in 1895, 2631-2642 in 1897.
RG described this four-coupled express American-type Eight-wheeler and a related six-coupled Ten-wheeler in the article cited above. Its commentary noted that over the previous ten years the average running speed over the many sharp curves and heavy grades had increased to 37 mph. Achieving the average required moments of 80-90 kph (50-55) mph running, which in turn demanded "large power'.
Engineering's photo shows the tall drivers, Belpaire firebox, heavy outside framing of the lead bogie, and the short cab. High-pressure cylinders lay outside of the frame and drove the rear axle; the larger low-pressures lay inside near the centerline and drove the leading coupled axle. Serve tubes inside the boiler added considerable tube heating surface area through the 8 1/2" (12.7 m) fins that lined the inner surface of the tube.
Data from "Four-Cylinder Compound Locomotive, C de F du Midi", Locomotive Magazine, Volume VI [6] (July 1901), p. 116. See also "220 n° 1 775 à 1 784 puis 220-775 à 784 du Midi" on the WikiMidi website at [], last accessed 31 October 2026. Works numbers were 5101-5110 in 1901
A photograph from Wikimedia shows the 1777's running gear in all its distinctiveness. Inside cylinders driving the lead axle aren't visible, but the valve gear and cylinders for the outside LP cylinders sit under the running board in line with the dome. Valve gear and long piston rod extend back to the rear drivers under the Belpaire firebox.
| Principal Dimensions by Steve Llanso of Middle Run Media | |||
|---|---|---|---|
| Class | 1751 | 1751 | 1775 |
| Locobase ID | 3893 | 3880 | 10190 |
| Railroad | Midi | Midi | Midi |
| Country | France | France | France |
| Whyte | 4-4-0 | 4-4-0 | 4-4-0 |
| Number in Class | 24 | 24 | 10 |
| Road Numbers | 1751-1774 | 1751-1774 | 1775-1784 |
| Gauge | Std | Std | Std |
| Number Built | 24 | 24 | 10 |
| Builder | SACM | Schneider-Creusot | SACM |
| Year | 1896 | 1895 | 1900 |
| Valve Gear | Walschaert | Walschaert | Walschaert |
| Locomotive Length and Weight | |||
| Driver Wheelbase (ft / m) | 9.84 / 3 | 9.84 / 3 | 9.84 / 3 |
| Engine Wheelbase (ft / m) | 24.93 / 7.60 | 24.61 / 7.50 | 24.70 / 7.53 |
| Ratio of driving wheelbase to overall engine wheelbase | 0.39 | 0.40 | 0.40 |
| Overall Wheelbase (engine & tender) (ft / m) | 45.41 / 13.84 | 43.83 / 13.36 | 50.39 / 15.36 |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | 36,156 / 16,400 | 35,053 / 15,900 | |
| Weight on Drivers (lbs / kg) | 91,933 / 41,700 | 72,312 / 32,800 | 91,933 / 41,700 |
| Engine Weight (lbs / kg) | 126,766 / 57,500 | 119,049 / 54,000 | 126,766 / 57,500 |
| Tender Loaded Weight (lbs / kg) | 53,793 / 24,400 | 53,793 / 24,400 | |
| Total Engine and Tender Weight (lbs / kg) | 180,559 / 81,900 | 180,559 / 81,900 | |
| Tender Water Capacity (gals / ML) | 4171 / 15.80 | 3300 / 12.50 | 4171 / 15.80 |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | 4.40 / 4 | 4.40 / 4 | 4.40 / 4 |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 77 / 38.50 | 60 / 30 | 77 / 38.50 |
| Geometry Relating to Tractive Effort | |||
| Driver Diameter (in / mm) | 83.90 / 2130 | 83.10 / 2110 | 83.10 / 2110 |
| Boiler Pressure (psi / kPa) | 198.70 / 1370 | 205.70 / 1400 | 201.30 / 1370 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 13.78" x 25.2" / 350x640 | 13.78" x 25.2" / 350x640 | 13.78" x 25.2" / 350x640 |
| Low Pressure Cylinders (dia x stroke) (in / mm) | 21.65" x 25.2" / 550x640 | 21.65" x 25.2" / 550x640 | 21.65" x 25.2" / 550x640 |
| Tractive Effort (lbs / kg) | 13,711 / 6219.21 | 14,331 / 6500.44 | 14,024 / 6361.19 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 6.71 | 5.05 | 6.56 |
| Heating Ability | |||
| Tubes (number - dia) (in / mm) | 111 - 2.756" / 70 | 111 - 2.756" / 70 | 111 - 2.756" / 70 |
| Flues (number - dia) (in / mm) | |||
| Flue/Tube length (ft / m) | 13.45 / 4.10 | 13.78 / 4.20 | 13.62 / 4.15 |
| Firebox Area (sq ft / m2) | 133.53 / 12.41 | 159.09 / 14.78 | 136.06 / 12.64 |
| Grate Area (sq ft / m2) | 26.47 / 2.46 | 26.48 / 2.46 | 26.80 / 2.49 |
| Evaporative Heating Surface (sq ft / m2) | 1883 / 175 | 1888 / 175.44 | 1858 / 172.58 |
| Superheating Surface (sq ft / m2) | |||
| Combined Heating Surface (sq ft / m2) | 1883 / 175 | 1888 / 175.44 | 1858 / 172.58 |
| Evaporative Heating Surface/Cylinder Volume | 432.89 | 434.04 | 427.14 |
| Computations Relating to Power Output (More Information) | |||
| Robert LeMassena's Power Computation | 5260 | 5447 | 5395 |
| Same as above plus superheater percentage | 5260 | 5447 | 5395 |
| Same as above but substitute firebox area for grate area | 26,532 | 32,725 | 27,389 |
| Power L1 | 6600 | 7120 | 6591 |
| Power MT | 316.55 | 434.14 | 316.11 |