Data from Wikipedia, [], last accessed 13 June 2010, supplemented by [], last accessed 14 May 2011.
Altensteig, Berneck, and Ebhausen served the 15.1-km narrow-gauge line south of Pforzheim The design included the Klose kinematic linkage, which allowed considerable play in the inner two axles and drove the end axles through a linkage from the third axle. The Wikipedia editor comments that, as with other Klose installations, the concept worked well, but required a good deal of maintenance.
Esslingen delivered the three over 8 years in 1891, 1892, and 1899. All remained in service until the DRG assumed control of the narrow-gauge line, at which point they were classed as BR 99 17. The last was retired in 1931.
| Principal Dimensions by Steve Llanso of Middle Run Media | |
|---|---|
| Class | Ts4 / BR 99.17 |
| Locobase ID | 11359 |
| Railroad | Altensteig-Nagold / Wuerttemberg State |
| Country | Germany |
| Whyte | 0-8-0T |
| Number in Class | 3 |
| Road Numbers | 1-3 / 99 171-99 173 |
| Gauge | Metre |
| Number Built | 3 |
| Builder | Esslingen |
| Year | 1891 |
| Valve Gear | Heusinger |
| Locomotive Length and Weight | |
| Driver Wheelbase (ft / m) | 13.12 / 4 |
| Engine Wheelbase (ft / m) | 13.12 / 4 |
| Ratio of driving wheelbase to overall engine wheelbase | 1 |
| Overall Wheelbase (engine & tender) (ft / m) | 13.12 / 4 |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | 16,535 / 7500 |
| Weight on Drivers (lbs / kg) | 65,698 / 29,800 |
| Engine Weight (lbs / kg) | 65,698 / 29,800 |
| Tender Loaded Weight (lbs / kg) | |
| Total Engine and Tender Weight (lbs / kg) | |
| Tender Water Capacity (gals / ML) | 634 / 2.40 |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | 0.90 / 1 |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 27 / 13.50 |
| Geometry Relating to Tractive Effort | |
| Driver Diameter (in / mm) | 35.40 / 900 |
| Boiler Pressure (psi / kPa) | 174 / 1200 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 13.39" x 19.69" / 340x500 |
| Tractive Effort (lbs / kg) | 14,749 / 6690.04 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 4.45 |
| Heating Ability | |
| Tubes (number - dia) (in / mm) | 140 - 1.772" / 45 |
| Flues (number - dia) (in / mm) | |
| Flue/Tube length (ft / m) | 12.17 / 3.71 |
| Firebox Area (sq ft / m2) | 58.10 / 5.40 |
| Grate Area (sq ft / m2) | 10.98 / 1.02 |
| Evaporative Heating Surface (sq ft / m2) | 777 / 72.20 |
| Superheating Surface (sq ft / m2) | |
| Combined Heating Surface (sq ft / m2) | 777 / 72.20 |
| Evaporative Heating Surface/Cylinder Volume | 242.12 |
| Computations Relating to Power Output (More Information) | |
| Robert LeMassena's Power Computation | 1911 |
| Same as above plus superheater percentage | 1911 |
| Same as above but substitute firebox area for grate area | 10,109 |
| Power L1 | 3415 |
| Power MT | 458.39 |