Mallet Data from []; and "2-8-8-0-Indonesia" in Wikipedia at [], last accessed 26 May 2026. Works numbers were 53154-53161 in 1916.
Dissatisfied with the rigid-wheelbase freight engines' insufficient power in mountainous terrain, Java State ordered this batch of eight Mallets from Alco and received the first six within six months. According to Wikipedia, the design represented a scaling-down to the Cape Gauge of a typical North American locomotive.
The result did not impress. Not only did the 1200s fail to run faster than 40 kph (25 mph) and thus fell short in a principal requirement, the HP and LP cylinders didn't balance the strains on the engine and frame cracks developed.
| Principal Dimensions by Steve Llanso of Middle Run Media | |
|---|---|
| Class | 1200/DD50 |
| Locobase ID | 4759 |
| Railroad | Java State/Staatsspoorwegen |
| Country | Indonesia |
| Whyte | 2-8-8-0 |
| Number in Class | 8 |
| Road Numbers | 1201-1208/DD5001-5008 |
| Gauge | 3'6" |
| Number Built | 8 |
| Builder | Alco-Brooks |
| Year | 1916 |
| Valve Gear | |
| Locomotive Length and Weight | |
| Driver Wheelbase (ft / m) | |
| Engine Wheelbase (ft / m) | |
| Ratio of driving wheelbase to overall engine wheelbase | |
| Overall Wheelbase (engine & tender) (ft / m) | |
| Axle Loading (Maximum Weight per Axle) (lbs / kg) | |
| Weight on Drivers (lbs / kg) | 184,626 / 83,745 |
| Engine Weight (lbs / kg) | 203,654 / 92,376 |
| Tender Loaded Weight (lbs / kg) | |
| Total Engine and Tender Weight (lbs / kg) | |
| Tender Water Capacity (gals / ML) | |
| Tender Fuel Capacity (oil/coal) (gals/tons / Liters/MT) | |
| Minimum weight of rail (calculated) (lb/yd / kg/m) | 38 / 19 |
| Geometry Relating to Tractive Effort | |
| Driver Diameter (in / mm) | 42.40 / 1078 |
| Boiler Pressure (psi / kPa) | 200.20 / 1380 |
| High Pressure Cylinders (dia x stroke) (in / mm) | 17.52" x 24.02" / 445x610 |
| Low Pressure Cylinders (dia x stroke) (in / mm) | 27.99" x 24.02" / 711x610 |
| Tractive Effort (lbs / kg) | 42,522 / 19287.68 |
| Factor of Adhesion (Weight on Drivers/Tractive Effort) | 4.34 |
| Heating Ability | |
| Tubes (number - dia) (in / mm) | |
| Flues (number - dia) (in / mm) | |
| Flue/Tube length (ft / m) | |
| Firebox Area (sq ft / m2) | |
| Grate Area (sq ft / m2) | 44.65 / 4.15 |
| Evaporative Heating Surface (sq ft / m2) | 2335 / 217 |
| Superheating Surface (sq ft / m2) | 560 / 52 |
| Combined Heating Surface (sq ft / m2) | 2895 / 269 |
| Evaporative Heating Surface/Cylinder Volume | 348.39 |
| Computations Relating to Power Output (More Information) | |
| Robert LeMassena's Power Computation | 8939 |
| Same as above plus superheater percentage | 10,637 |
| Same as above but substitute firebox area for grate area | |
| Power L1 | |
| Power MT | |